Refresh page or whitelist this site in you Ad-block if you are seeing this
.

How to install TWRP custom recovery in Tecno Spark K7 and root


You may want to root your Tecno spark K7 so you can get full control over the device. First you have to meet some requirements.

Requirements for rooting Tecno Spark K7

  • A PC with Vcomm drivers and ADB drivers installed
  • Spflashtool
  • TWRP for Tecno Spark K7
  • SuperSU


Download TWRP and SuperSu here

How to install TWRP custom recovery in Tecno Spark K7 and root
1. Flash TWRP using Spflashtool.
2. Copy SuperSU to Memory Card
3. Boot to the TWRP custom recovery
4. SuperSU in Memory Card, Install via TWRP
5. Reboot while ignoring TWRP warning.
 
You may want to go back to the previous factory build after the root


If you wish to restore Stock recovery after root. Warning: Factory Reset is likely to brick your device if TWRP is the recovery currently used by the phone. Stock file is in downloaded file.


1. Proceed to safe measure by turning off phone again and flash STOCK RECOVERY via         SpFlashtool.
2. Reboot and enjoy

Note: This works for  Tecno Spark K7-H8019A-N-170731V73 
Disclaimer: Do at your ow risk

6 comments:

  1. The twrp is not working even after flashing it correctly using sp tool

    ReplyDelete
  2. What if I need to take K7 to Lollipop 5.1?

    ReplyDelete
  3. What if I need to take K7 to Lollipop 5.1?

    ReplyDelete
    Replies
    1. you may have to root and get a custom ROM

      Delete
  4. I can't install the twrp file for the techno spark k7 is that correct file

    ReplyDelete

Leave A comment